SmartPTT RG-1000e Radio Gateway
RG-1000e is a hardware radio gateway that is used to connect various (MOTOTRBO and non-MOTOTRBO) radios to SmartPTT Radioserver using IP connection in private networks or Internet.
- Supports non-MOTOTRBO radios*
- Connects up to 2 control radios to each RG-1000e for parallel operation
- Support of incoming voice detection (RX Audio VOX)
*Provides voice-only features for non-MOTOTRBO radios
Top Solution in Verticals
- Transportation
- Logistics
- Energy
- Oil & Gas
- Public Safety
- Ambulance
Description
Benefits
- Easy configuration and deployment of the system
- Absence of radio frequency interference geographically distributed control stations
- Time and resource effective deployment of radio systems
- Operation in harsh environments
- Cost reduction
- Decreased number of radioservers required
- No expenses on soundcards for the radioserver
- Low-cost maintenance of the system
Especially needed if
- There is no direct IP connection of radio servers to repeaters or the solution architecture does not provide this feature
- The radioserver soundcard does not support a sufficient number of audio channels to connect to control stations
- In case of narrow frequency range to avoid interference between control stations (for example, some airports)
- For communication between subscribers and dispatchers in locations, where installation of repeaters is not economically feasible
Features
- Connects up to 2 control radios to each RG-1000e for parallel operation
- Can be connected with multiple radioservers (up to 8 IP connections to one RG-1000e)
- Supports MOTOTRBO digital and analog modes (including one digital and one analog simultaneously)
- Operates in the following MOTOTRBO topologies: Simplex, Conventional, IPSC, Capacity Plus, LCP, Capacity Max
- Supports High Tier and Middle Tier mobile radios
- Can be configured and updated remotely
Specifications
Network Interface Parameters
- Connector RJ45
- Standard 10BASE-T (IEEE 802.3) / 100BASE-TX (IEEE 802.3u)
- Supported TCP/IP protocols UDP, ICMP, IPv4, ARP
- Auto tuning of auto switching Transmission rate—10/100 Mbps,
Operation mode—duplex/half-duplex, Auto detection of the cable type—Auto-MDI/MDI-X
Power
- Power supply voltage 10.5 to 15.0
- VDC Power consumption 2 W or less
Design
- Gateway dimensions 180x144x30 mm (7.09×5.67×1.18 inches)
Operating Conditions
- Operating temperature –20° to +60°C (–4° to 140°F)
- Humidity 5% to 85% at 30°C (86°F)
- Operating hours 24×7
Note: MOTOTRBO control stations should be purchased separately.
